Single-phase voltage stabilizer 230Vac 1000VA AVR SERVO

FEATURES

-Accurate, (±3 % accuracy) with fast response AVR

- High quality toroidal transformer

- AVR can best protect your connected equipment against voltage fluctuations

- Servo motor

- Liquid crystal display

- Applicable for: computers, lighting equipment, audio equipment, TVs, office equipment, etc.

FRONT PANEL

1. Power switch (if the load current exceeds, the unit will automatically switch off.

To switch it back on, reduce the load current, then set the power switch to "ON").

2. Input voltage

3. Output voltage

4. Overvoltage

5. Insufficient voltage

6. Retrieved from

7. Warning/abnormal operation

8. Time icon (6 seconds default delay activation)

9. Normal operation

REAR PANEL

1. Output slots

2. Fuse

3. Input

INDICATION

RADIO FREQUENCY INTERFERENCE

This product may not function properly if it is located near equipment that emits radio

waves. Place this unit away from such equipment to avoid interference with the power supply.

SAFETY INSTRUCTIONS

- Do not overload the voltage regulator. Operating this unit at a load higher than the rated load may damage this unit. Do not operate the voltage regulator beyond its maximum capacity.

- This device is intended for domestic and office use. Do not use this voltage regulator with

specialised equipment (e.g. industrial, medical equipment).

- When the voltage stabiliser is connected to any appliance with a high instantaneous starting current, the starting power is usually several times the specified power of the appliance.

Make sure that the total starting power of all connected devices does not exceed the specified maximum output power of the stabiliser. For example, for a TV set, calculate twice the specified power.

- Make sure that the output voltage and frequency of the regulator are the same as the connected appliance.

- Place the appliance in a suitably ventilated area at an acceptable temperature.

- Warning: Do not cover the cooling fan or the vents of the appliance; this may cause overheating.

- Keep this appliance away from water, moisture, heat sources and direct sunlight.

- Do not use this device if it is not working properly. In this case, the appliance

immediately switch off the appliance and disconnect it from the mains.

- Do not disassemble this appliance or open the casing. Any repairs can be carried out

removal only by an authorised service centre.

- In case of fire, use only dry powder extinguishers. The use of water or other types of fire extinguishers may cause electric shock.

- Always place the controller in a well-ventilated area out of direct sunlight or heat source and away from any combustible materials. Keep the unit out of the reach of children.

- Disconnect this device from the mains if you will be using it for a long period of time.

- The power cord should only be replaced by an authorised service centre.

- Power cord protection: power cords must be routed in such a way that they are not

can be pinched by objects placed on or against them. Pay particular attention to

to the cords, plugs and power sockets and where they exit from the appliance.

- This appliance may be used by children over the age of 8 years and persons

with impaired physical, sensory or mental capacities, or who are inexperienced and

knowledge, provided that they are supervised and guided by a person responsible for safety .

TECHNICAL SPECIFICATION