Filament SUNLU High-Speed Matte PETG (red)
Доставка
SUNLU High-Speed Matte PETG Filament (red)
SUNLU High-Speed Matte PETG is a 3D printing filament that allows you to print at speeds ranging from 50 to as high as 600 mm/s while maintaining smooth extrusion and good surface quality. The increased fluidity of the molten material ensures smooth filament feeding during high-speed printing, while good layer adhesion and a design that minimizes the risk of nozzle clogging contribute to stable operation. The matte, low-gloss surface reduces reflections and gives models an aesthetic finish, making the material suitable for both functional and decorative prints. The filament diameter is 1.75 ±0.02 mm, and each spool contains 1 kg of material, approximately 330 m in length.
Up to 600 mm/s and a smooth, matte finish
High-Speed Matte PETG can be used at various print speeds—for 50–100 mm/s, the recommended nozzle temperature is 205–215°C; for 100–300 mm/s, it is 240–250°C; and for 300–600 mm/s, 260–270°C should be used. The material combines high printing speeds with good strength, flexibility, and resistance to impact, wear, and various chemicals, making it suitable for prototypes, functional parts, mechanical designs, and DIY projects, among other applications. The tensile strength is 48 MPa, the flexural strength is 78 MPa, and the elongation at break is 33%, which allows for the creation of durable models with good layer adhesion.
Optimal Conditions for Stable Printing
The recommended bed temperature is 60–70°C; at 70–80°C, no adhesive is required; however, if using an unheated platform, adhesive must be applied. Due to its increased fluidity, PETG is more susceptible to moisture, which can cause stringing, material leakage, and a deterioration in print quality; therefore, the filament must be thoroughly dried before printing and protected from moisture during long print runs. The recommended humidity during storage and printing is below 20% RH when stored in an airtight container with a desiccant, and the drying setting is 50°C; for SUNLU S4/E2 dryers, 65°C for at least 8 hours is recommended.
ManufacturerSUNLUNameHigh-Speed Matte PETGColorRedMaterialPETGFilament Diameter1.75 ±0.02 mmPrint Speed50–600 mm/sNozzle temperature for 50–100 mm/s205–215°CNozzle temperature for 100–300 mm/s240–250°CNozzle temperature for 300–600 mm/s260–270°CBed temperature60–70°CBed temperature without adhesive70–80°CRecommended humidity
Отзывов пока нет — отзыв можно написать из своего заказа после покупки